Feet Tracing Instructions
Please
trace your foot following exactly the following steps. The fax
machine occasionally changes the size of the tracing so we need you
to put measurements on it for us as you will see below. Then when
the fax arrives, all we need to do is double check the measurement
you gave us to make sure it matches.
Instructions:
With both
feet traced like this:
● Use a
sheet of clean white paper
● You
must be standing with bare feet.
● Trace
one foot at a time.
●
Pen must
be vertical (not at an angle)
●
Place your
bare foot diagonally on the paper (leave a 1cm boarder).
●
Use a
black pen, but not thick one.
●
Trace all
the way around your foot
●
Remove the
first foot and repeat with the 2nd foot crossed over the
first one on the same paper.
●
Trace 2nd
foot.
●
Draw a
vertical line down the paper.
●
It must be
at least 10” or 25cm ideally it should be the length of the tracing.
●
The
reason for the line is so I can check if the fax has changed the
tracing.
●
I need a
small horizontal line at each end of your vertical line so I can
clearly see where it starts and finishes.
●
Lastly I
need you to write the EXACT measurement of the line, on the line.
● Add your
name, phone number and email address.
●
It should look like
this when you are done:
Our fax # is: +
86 591 87 30 80 08.
If that number is busy try our other office number but make sure it
says 'Attention Wynne' on it:
+
86 591 83 91 18 08
Any questions,
just ask.
|
