The Bont GT3 blade gives you the equipment you need to be your best.
The GT3 is made with the best Japanese knife steel. It also benefits from all the technology, research and development of the new Platinum blade. This blade has the same materials as the Platinum apart from the steel. The GT3's steel is tempered using our 20+ years of short track blade making expertise.
Consistency has been the focus of our new GT3 blade. Machining time is expensive and blade manufacturers grind the steel in batches at high speeds to reduce costs. This results in the steel warping due to the high temperature of the grinding stone grinding the steel. Our aim for the GT3 and the Platinum was to make every blade the same so we purchased the best grinding stones from Germany and we slowly grind one set of steel blades at a time. This is an extremely slow process with higher costs but the result is steel that has no warping. All skaters, not just Olympians, should enjoy perfect blades. However, we didn't stop with the grinding. We looked at the other aspects of making the blade even more perfect. We developed a new stronger glue that allowed us to reduce the tube slot width by 0.1mm. The tube slot needs a certain amount of room for the glue on either side of the blade. The greater the gap, the more chance the steel has to warp while the glue sets. By reducing this gap, we improved the consistency of the straightness of the blade after gluing. Lastly, we invested heavily in jigs. Each blade is clamped in 9 locations while it sets and we let the blades set for 14 hours until the glue has fully cured. This means that we can only make a few sets of blades per day, but each set is perfect.
Aluminum tubes do not like to be bent. They always spring back to the straight position. To solve this problem, we have two solutions: