Bont Short TrackBont Short Track

manufacturing

Bont’s method of producing skates by hand inside out is a process that is far more skill intensive, time consuming and thus resulting in far greater costs than the current mainstream skate construction methods, but one that allows the Bont range of skating skates to lead the market in performance. The Bont production line has been engineered by founder Inze Bont to allow for our monocoque skates to be hand made in the most time efficient manner possible. This is a process which continues to be developed and refined. Inadequate processes such as using generic vacuum boxes for curing the carbon have been replaced by methods such as pressure wrapping which provides four atmospheres of pressure rather than the traditional one atmosphere from vacuum forming. Bont’s drive for design innovation is matched by its innovation in manufacturing processes.

the last

We start with the last (plastic foot) which has been crafted by a combination of the latest technology and over 36 years of experience. We used data from 20,000 laser foot scans to develop a standard last, we then merged that with Mr. Inze Bont’s 36 years of making custom speed skate/performance footwear and the ongoing feedback received from professional riders. The result is one of the finest skating last created.

Foam Padding

the footbed

The footbed is the first part of the skate added to the last. It is made in-house from a heat moldable EVA. The footbed is 65A hardness and only 3mm thick which makes it extremely light weight and heat moldable.

Foam Padding

the liner

The liner is then added which has been chosen out of hundreds of liners. This liner is not only light weight and strong, but it fights odour and is not easily broken down by sweat.

Foam Padding

anti-stretch tapes

Anti stretch tapes are then added. These tapes are similar to seatbelt material and ensure the boot does not stretch over time.

Foam Padding

carbon fiber

We then hand lay the carbon paying particular attention to the stress it will need to bear whilst skating. Each and every layer is laid with a purpose. We use cross weave 3K 198 gram aircraft grade carbon on the outside and unidirectional carbon on the inside. The uni directional carbon has only half the strands of cross weave carbon. It gives strength in one direction so it saves weight by using less carbon and absorbing less resin.

Foam Padding

the upper

The light weight upper is then glued and sewn onto the shoe. Holes are hand punched through the uppers and the liner for ventilation. The buckles and straps are attached. The location of the straps is such that they pull the foot down and into the back of the shoe. The excess glue is cleaned off and the shoe is ready to be ridden in. The shoe has passed through 16 independent stages of quality control for it to be deemed ready for action. The result is a shoe with the best strength to weight ratio on the market.

Foam Padding